I have found out that after full wipe you are not able to install globe rom, I have Redmi 4 prime. I have updated to latest stable from earlier stable, I'm always doing full wipe in twrp. I was able to install the rom (in twrp), but I could not restart the phone into system from twpr or just shut it down, the phone always freeze after I pressed the restart button or turn off, or reboot back into recovery etc. I had to hold the power button, then it rebooted after 30second and stuck at the MI logo, all the time. Then I was able to get back into twrp only by pressing power, volume down and volume up at the same time. I have tried to install that rom couple of times and always with the same result. Then I have found out on xda forum, that some lazypatcher zip file as to be installed while still in twrp, it skips some checking of phone/rom encryption or whatever(new stuff from xiaomi). After that I booted into os, however it was pure os, without any custom stuff like adaway, mixplorer or any that stuff I have selected by building the rom. Then I had to go back into twrp again and install the globe rom again, over the same rom which I have installed before (now without wipe as it would create again the same loop as mentioned before). After I did that and rebooted I saw the globe loading animation and all the wanted stuff was in there. I have to say that it never happened to me with any rom just with yours. I believe that you are adding into it (or maybe you are deleting/changing) some part of code (besides of the part of code which is adding adaway and removing stuff like xiaomi service) which makes this difference. I had never any problem with the same rom from miuios.cz, which should be the same rom as xiaomi.eu rom, which should be the same base rom you are using in rom builder. But there has to be some tiny but still major difference which is always making this problems to me by installing your custom stable roms from rombuilder. It would be great if you could investigate that somehow. Phone is working fine now, but the installation of the rom after full wipe is crazy and it takes some time and knowledge to overcome the problems. I have to say that my phone was never encrypted, but only after the lazypatch zip file I was able to boot into the clean os. Thanks for reading

Edit: Ok, this might not be a problem caused by you/rom builder as one other guy on other forum reported the same 'stuck at mi logo' shit on his prada device and last stable xiaomi.eu rom. This has to be some higher problem on china roms I guess as the eu roms are based on china roms.